Danner 02525 500 GPH Pond Pump With 18-Foot Cord Rating :
Product Details
- Amazon Sales Rank: #10648 in Lawn & Patio
- Size: 500 Gallon
- Brand: Danner
- Model: 2525
- Number of items: 1
- Dimensions: 4.50" h x
5.50" w x
5.50" l,
Features
- Suitable for medium garden fountains, piped statuary and ponds
- 500 GPH Maximum Flow with a 10-foot6-inch Shut-off
- Ceramic shaft
- Pre-filter included
- Operates submerged or in-line
- Suitable for medium garden fountains, piped statuary and ponds
- 500 GPH Maximum Flow with a 10-foot6-inch Shut-off
- Ceramic shaft
- Pre-filter included
- Operates submerged or in-line
Product Description
Magnetic drive pumps are made to run continuously, without seals to wear out. Highly energy efficient, the savings pass on to the consumer. Being filled with epoxy, not oil, they cannot leak oil into the pond. All Pondmaster pumps are suitable for statuary, fountains, ponds and/or aquariums.
Customer Reviews
Most helpful customer reviews
1 of 1 people found the following review helpful.
Same Pondmaster quality.
By Dodgeboy
I've purchased several Pondmaster pumps over the years because they are inexpensive but well made. They are also cheap to operate and will not run up your electricity bill. I must admit my pond is not exactly clean so I have quite a bit of debris that gets sucked into the pump, sometimes requiring a good cleaning. Mine came with a plastic-cage pre-filter (a must, don't use the foam kind!) which I have to clean about once a week. The 18ft cord is a definite plus for reaching your power outlet. This is a well made quality pump for the price.
1 of 1 people found the following review helpful.
Good pump for pond and aquarium use
By K. Lin
This pump is the most reliable pump that I have used for aqurium/pond application. After 18 months of running 7 by 24, the pump is still going strong.The only issue I had so far is that the pump seem to run noisy with reduced flow recently. After opening up the cover a couple times, I figured out the reason for the noise. What happened was the alignment of the impeller went off a little and resulted in the impeller blades scraping the front cover. I put in a tiny spacer to push the impeller away from the cover. The trick restored the pump's performance and output back to 100%. It is running like new again.
1 of 1 people found the following review helpful.
Pond Master 500 gpm submersible pump
By Ettore Zuccarino
Excellent design. would last many years were it not for the fact that the shaft bearings are made of rubber and wear out in little more than one season. Kits are available to replace the rotor with new bearings, but they are pricey
0 comments:
Post a Comment